DC Audio A3 5.0kw Monoblock Subwoofer Amplifier

$1,480.00
In stock
SKU
DCA-AMP-5.0K

The 5.0kw competition series amplifier is a 5,000 watt mono block. It is capable of running up to 18 volts for up to 7,300 watts. It is a linkable amp and designed to run a 1 ohm per amp or 2 ohms when strapped.

It comes with a bass knob and a clipping indicator. For power inputs it will accept dual 0 awg for power and dual 0 awg for ground.

Key Features

• 1 ohm stable

• Variable low pass filter

• Variable subsonic filter

• Variable bass boost

• Wired remote control

• Clipping indicator

• Dual 0 awg power and ground inputs (both must be used)

We recommend for installation

• 1 upgraded battery under the hood

• 1 extra 800ci battery in the rear

• Minimum of two 0 awg ran from the front battery to the rear battery

• Both 0 awg power and ground inputs on amp must have 0 awg ran to them for a total of 4 runs into the amp

• Upgraded aftermarket alternator

• Dash mounted voltage meter

Features Voltage 5.0kw
Output Power (RMS) 4 ohm 14.4V 900Wx1
  2 ohm 14.4V 2,300x1
  1 ohm 14.4V 5,000Wx1
  1 ohm 16V 6,000Wx1
  1 ohm 18V 7,300Wx1
Input Sensitivity 6V~0.2V    
Low Pass Filter Switchable    
( @ 24 dB Slope) Variable Hz 35~250
Subsonic Filter Switchable    
( @ 24 dB Slope) Variable Hz 10~50
Bass Boost Variable dB 0-9dB
Frequency Response   Hz 15-270
Signal to Noise Ratio   dB 100
Damping factor     150<
Efficiency @ 4ohm   % Over 90%
THD @ 4ohms Less than 0.1%
Fuse Rating 500 Amps
Linked Fuse Rating 1,000 Amps
Indicator Power   Yes
  Protection   Yes
  Clip   Yes
Speaker & Power terminal Mold Type   Yes
  Power Gauge 0Ga
Heatsink Length 25.59" (650mm)
Heatsink Width 9.38" (238mm)
Heatsink Height 2.35" (59.6mm)
Write Your Own Review
You're reviewing:DC Audio A3 5.0kw Monoblock Subwoofer Amplifier